sheddist clutch quick question

[Adam 180 V6]

hi this may seem like a really dumb question, but on the sheddist clutch kit how do you get the cap of the fluid resovoir? ive tried twisting it and pulling it and it doesnt seem to want to come off, im scared im gunna break it, Any help would be appreciated

[stamford]

It is a tight fit on the 'o' ring seal, try visegrips with some masking tape over the jaws to prevent damaging the cap. When refitting it slap some Vaseline around the seal.

[Adam 180 V6]

Originally Posted by stamford

It is a tight fit on the 'o' ring seal, try visegrips with some masking tape over the jaws to prevent damaging the cap. When refitting it slap some Vaseline around the seal.

so im guessing its screw on rather than push on? And thanks

[stamford]

No it is a push-on cap, uses an 'o' ring to seal it. Just a tad bit tight that is all.

[Craig-ZS180]

Mines a push on, tight as you like and I think Mick was just saying that so you could give a wiggle back and forth to help it on its way.
It will eventually come off.

[Adam 180 V6]

Thanks very much for youre help, im topping it up with dot 4 brake and clutch fluid, is that ok?

[stamford]

Yes that is the standard stuff.