switches

[peterzs]

Originally Posted by Rossy

Thanks yeah that's the ones will get some photos up will find out how to do it .. absolutely hosin it down here but will do .. also became a subscriber for all the help and advice the site gives ...THANKS ...

Thanks for becoming a Subscriber, all helps to cover the costs of running the site.

Best of luck with the switches, plus the console update.

[Smokey]

I addition mate, you'll need to wire leds if you are replacing the fog switches as the savage ones don't look like they have tell tale lights to show the fog lights is active. This is an MOT requirement. I wired two wee leds which took me 10 minutes.

[Rossy]

Thanks guys for all the advice mucho appreciated !!! re the fog lights have not got to them yet but have replaced the leds in them with blue ones to go with the blue colour scheme I'm trying to achieve.My biggest problem I think is going to be the hazard switch to what I can find on other places seems to be a hard one to connect up !!!! ,the savage hazard switch has 8 terminals on the block connector and I have 9 wires on the original mk1 switch .Got another hazard switch on the bay but I think it's from a mk2 a lot less terminals on that one to... now comes the scratch the head time and look sensible !!! which I'm not although I do own a MG ZS 180 in Trophy Blue which must count for something ...

[Smokey]

Haha, there is defo some brains in there somewhere then!

On my switches, I don't use all of the wires connected to the original switch either. For example, some have 2 black wires which are both a -ve feed (one for tell tale light, one for normal light) so for my new switch, was redundant. I had to rewire the whole console to make things easier for myself. But I did note down everything!