Quote:
Originally Posted by peterzs
|
been doing pod for a few years, diddnt go this year, 13.5 @104 iirc, 2.260ft best 60ft i gained was 2.0 but car is striped out.
Quote:
Originally Posted by garymgzs180
hi ross. i had the same problem with mine melting the spider . the oil could not escape from the specified hole as the gear that runs close to it whips it away (a technique used on jet engines) and so the oil level built up into a bath and the gears boiled the oil. i am using the original oil inlet jet and pipe so there is loads of oil getting in and cooling. i drilled a hole at the lowest point of the snout and returned the oil to the very base of the camcover. i know the oil will drain away from the snout when not running but the gears hold a hell of a lot of residue and will not be damaged when starting the car. yeah george at rsm did the bearings for me. my kit came with the perfect power piggy back ecu. it is a very good unit and does not fail like the early units they supplied. advantage of the smt7 is that you can modify the ignition timing and the fuelling. it is very easy to use and tune. my boost gauge was only showing 4 psi when i first innstalled it.it only shows 5 psi now i have changed the valve overlap. it may just be that my gaige is not very accurate and it may be actually running 6 psi now. i did contact piper to see if they can make me so custom camshafts with higher lift and less duration which is better suited to superchargers but they have not been very helpful so far. are you running standard cams. yeah we should meet up at some point
|
what oil return did you use? there is one in the bottom of the snout anyway, which as you say whips it away, my concern with yoursetup is the amount of oil it takes to get to the bearings on the gears, it has to run through 2 bearings, wich are rotaing very fast, if i start my car up and undo where your car feeds it takes some time to see oil up there, it possibly would work the other way. if the gears melt then it will wipe the charger, which i have found out is no longer avaible from anybody at all... the unit has been discontinued at opcron, whipple no longer do one the same size and sprintex claim to have 0 lol...
when the spider bearing melted did it stink lol, before we ran oil feeds it had a oil bath, and that was the worst setup ever..
what you have to remembed is the supercharger runs of the aux belt, to get more psi is obviously to change the pully, my car peaks at 6/7psi for a tiny bit also, but not looked into why. i know about the perfect power ecu, looked into it myself but decided to go the DTA route as then i can change everything i like, its risky running the 7th injector the way it is, i did 2 years before my car blew up last time so do hope it all goes ok for you...not sure if your going to the x mas meet, but i will go to that if your going mate
Quote:
Originally Posted by rozzr
i'd love to hear the noise of a s'charged KV6, has anyone got a video of one in action, drive by or something would be great?
very nice looking car btw mate, perfect!
|
http://www.youtube.com/watch?v=K43zN2OazBQ my car on rollers at vauxsport, says 243 but iirc it was underreading on the day as the run downs wernt right, it did make 219bhp@atw. a rolling road some months later with some mapping it made 229bhp@atw at a different rolling road turn it up loud lol