Stamford’s ZS180

[stamford]

Originally Posted by maxtherotti

You don't fancy the brembodge brake set up then?
Keep thinking about that myself

Rob

Can't justify the cost, the calipers cost a fair bit these days and still require a refurb. Anyway the standard set-up is more than adequate for my needs and have never had any braking issues, just fade when overworked on track.

[talkingcars]

I think they are meant to reduce brake squeal as well.

[stamford]

The guys at MTEC have checked the pad boxes in the warehouse and the Mintex pads do not include shims, so need to source some, rears definitely, fronts not been stripped yet but might as well.

[Craig-ZS180]

That's strange that they don't come with them, from when we've dealt with them at work they usually come with a rubber backing shim (anti squeal backing) that is actually stuck onto the back of the pad.
I know the ebc's do and I really cannot fault them on my car, on track or road have always been brilliant with no fade and work really well even from stone cold.
I honestly thought that Mintex came with them too as most suppliers do now when of a good brand.

[POMPSKI]

Neither my front nor rear mintex had shims when I changed them last year. I re-used the originals.

[talkingcars]

I wouldn't get drilled discs on a road car, they tend to crack more easily due to heat/cool cycles.

Although I like the apperance and braking of groved discs they are a tad noisy compared to smooth.

[ZS]

Apparently a lot of drilled discs are just std discs drilled and then put on the market, which means they are not treated in the correct way and have a lot less stress than standard and crack\fail a lot more than they should...

So if you do go with drilled and grooved discs then I would look for known brands and avoid the cheap options.

[stamford]

In between other jobs I managed to do Sunday:

Stripped both rear coilovers, had to use alot of heat on the platform collars as both were seized solid. This took some time to shift, managed to reset them 20mm higher. Hopefully be able to tweak the height once on the car but can't be that far off from where it needs to be, roughly 40mm drop max. I think these will be replaced at some point for some new ones.

Got back under the car to tackle the LCAs, started on the nearside arm, got all the bolts out and got to the inner one, same as the offside, this seemed to be going well, the breaker bar started to make some difference then 'snap'! So I will either attempt to drill through but a cutting disc looks favourite here as the arm will not be re-used. Same needs to be done on the offside one as the bolt head has rounded off and this was using a 6-side impact socket!

Tyres, brake set, hoses should be here Weds/Thurs. So will require getting the tyres fitted at some point. I'll be needing an arch roller to fettle the fit as well. Anyone have one to hire?

[peterzs]

Moving onwards and upwards, bit hot Sunday, specially using heat.

Dont over do it, little and often I'm told.

[stamford]

Been informed my tyres arrived this morning. Looking forward to getting these fitted and seeing what the score is on clearance!