|
Piping
I managed to get a K&N filter with an ITG Style pipe for the throttle body so no messing about with a separate breather filter.
I have been given a light aluminum 45 degree bend and a straight peice by a mate at work and I just measured the ID and it is 73mm. I have never seen them that size before.
I will need a 90 degree coupler but what size should I get? Bearing in mind that at one end it will attach to the hard plastic (ITG Style) pipe which I believe is 70mm as it was attached straight to the throttle body and the other end will attach to the 73mm aluminum pipe.
Any ideas what will fit?
__________________
 <!-- Facebook Badge START --><a href="https://www.facebook.com/Johnwaynesboots" target="_TOP" style="font-family: "lucida grande",tahoma,verdana,arial,sans-serif; font-size: 11px; font-variant: normal; font-style: normal; font-weight: normal; color: #3B5998; text-decoration: none;" title="Kirk Sherratt">Kirk Sherratt</a><span style="font-family: "lucida grande",tahoma,verdana,arial,sans-serif; font-size: 11px; line-height: 16px; font-variant: normal; font-style: normal; font-weight: normal; color: #555555; text-decoration: none;"> | </span><a href="http://www.facebook.com/badges/" target="_TOP" style="font-family: "lucida grande",tahoma,verdana,arial,sans-serif; font-size: 11px; font-variant: normal; font-style: normal; font-weight: normal; color: #3B5998; text-decoration: none;" title="Make your own badge!">Create your badge</a><br/><a href="https://www.facebook.com/Johnwaynesboots" target="_TOP" title="Kirk Sherratt"><img src="https://badge.facebook.com/badge/1011934393.3054.324244859.png" style="border: 0px;" /></a><!-- Facebook Badge END -->
|
Linear Mode
