Well my redundant driver's seat has sat in the garage for months getting in the way and had a plan for it. Tonight I finally pulled my finger out and did it!
I used my current office chair chassis. Removed all the seat brackets and pushed the front and back bars right down. The next bit means making a plate up that fits across the two height bars and then bolting the old chassis to this etc. Luckily for me I had a piece of plate that was a perfect fit and had returns folded on them in order to locate the plate around the seat bars.
After sitting in it for a while this evening I definately need to do something with the seat height at the front as my feet are not touching the floor and I can feel a dead leg coming on! The old seat design was flatter whereas these come up at the front. I might be able to refit the springs and get the tilt back. It doesn't need much.
does the airbag still work...cos wouldnt want you getting hurt while drinking driving that chair...especially with wheels that dont have a steering wheel...
__________________ SPANK THE MONKEY CREW : official member
does the airbag still work...cos wouldnt want you getting hurt while drinking driving that chair...especially with wheels that dont have a steering wheel...
lol! next thing to do is hook up the heated seats for those winter mornings when you just got outta bed and are about to check your email!
__________________
MG ZR 105 2003 - sold
MG ZR 105 2004 - dead
MG ZR 105 2002 - dead
MG ZR 120 2003 - sold
MG ZR 105 2002 - sold
MG ZS 120 2004 - sold
Ford Focus ST 2007 - CURRENT!
A good use for my ZS180 driver's seat
heated seats!
Linear Mode
