Reverse Sensors Wiring

[Z Scotland]

Originally Posted by DeMoNPauL

The ones off ebay work great. Easy to fit too. I paid £15 for ours.

+1

[will-w]

Seems like you've made my mind up then!

Did you get these ones? http://cgi.ebay.co.uk/ws/eBayISAPI.d...m=190322960277

[SheppeyTrio]

Yeah, they look good! I suppose it doesn't matter about being original mg 1's!

[SheppeyTrio]

i've bought 2 sets, 1 4 mine and 1 4 my otherhalves car!

[Jay-ZS+]

how difficult is it to wire up on a mk1 I wonder? obviously the bumper doesnt have the holes but thats ok I own a hammer

[SheppeyTrio]

Originally Posted by Jay-ZS+

how difficult is it to wire up on a mk1 I wonder? obviously the bumper doesnt have the holes but thats ok I own a hammer

The kits i bought come with a holesaw!!

[Jay-ZS+]

lol I was kidding have all the kit to do it just wondered about the wiring, assume theres nothing there on the mk1s, Think I might look into it as the new flat has off road parking... ( for a KA maybe) the zed hangs onto the pavement unless touching the wall! lol

[RudeDogg1]

u just push the power cable into the reverse light connector on the rear cluster simples

[Z Scotland]

Originally Posted by Jay-ZS+

how difficult is it to wire up on a mk1 I wonder? obviously the bumper doesnt have the holes but thats ok I own a hammer

These are really easy to wire and fit.

Remove bumper! Mk2 are marked on the inside where to cut, Mk1 you will have to use your own judgment.

Wiring is simple! position the control box in the boot either to the left or right behind carpet. The red wire taps into the reverse light and the black to an earth then you plug this in to the control box. Then fit the sensors to the bumper and feed through a grommet at the back of boot (lift bumper into position at same time) and plug into control box. Finally plug in the bleeper to the control box and position appropriately.

Attach bumper and test: Job done.

Hugh

[KevG]

BMW PDC controller, same as the Rover unit on ebay