VIS pcb's

petet16 · 25-03-13, 12:47 PM

Would these be the same as the pcb's in zs vis motors ?

http://www.ebay.co.uk/itm/Rover-75-Z...item417130e1e5

Craig-ZS180 · 25-03-13, 12:54 PM

May be wrong but I was under the impression the vis motors were all the same. Im sure mine that are currently on the zs were off of a zt when I got them? Wouldve thought they would do the job.

POMPSKI · 25-03-13, 01:02 PM

If they are, I hope he is prepared for a massive increase in demand

petet16 · 25-03-13, 01:29 PM

Quote:

Originally Posted by Craig-ZS180

May be wrong but I was under the impression the vis motors were all the same. Im sure mine that are currently on the zs were off of a zt when I got them? Wouldve thought they would do the job.

I was pretty sure they were all the same, but his application lists only show zt/75 so I thought I'd stick the question out there.

Craig-ZS180 · 25-03-13, 02:20 PM

Quote:

Originally Posted by petet16

I was pretty sure they were all the same, but his application lists only show zt/75 so I thought I'd stick the question out there.

His listing does miss lead a bit I think as ive always been led to believe that the motors are the same on all the manifolds. Dont think there would be a difference between them.

petet16 · 25-03-13, 02:30 PM

I just checked the motor part numbers, they are the same for zs/45 and zt/75.

DuckFeet · 25-03-13, 02:56 PM

Now if he could source oil resistant (brushless) motors these would be fit and forget surely?

KevG · 26-03-13, 10:08 AM

This is Stocktake (Dave) on the 75/ZT forum who is selling these.

The PCB is for Balance only, and has a facility for adding a test switch, it also has solder pads for adding the outsource motor that he fits.

DuckFeet · 26-03-13, 10:21 AM

Quote:

Originally Posted by KevG

adding the outsource motor that he fits.

Link please? I'll have a go at searching for it.

http://www.75ztcommunity.co.uk/vis-m...-t4384-20.html

KevG · 26-03-13, 10:24 AM

All I know is that the motor are specially made for a company in America.